Z Offset Direction Direction – Marlin 3d printer (Anet A8, Tronxy P802M …)

Every time I needed to adjust the level between a bed and an extruder, I checked a manual document.

It is confusing. What if the offset number is increased, is that extruder going to go DOWN or UP?

Sometimes, I tried without manual but it is scaring. “What if the extruder scraches the bed because extruder goes down too much?”

I don’t want this. So, I made this image for myself.


I think it is worth to share to others.








You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *